I want to check the float height on my 55w using the drain tube up the side of the carb method. Ive found three different figures on the internet.
Can anyone tell me what the correct figure is.
Heres a pic of the level on mine.
Thanks.
Correct float height
-
simplesimon1
- No Gold Stars Yet
- Posts: 43
- Joined: Thu Sep 22, 2016 6:46 pm
- What Bike or Bikes Do You Own?: xt600z 1vj
- Previously Owned Bikes: xt600 34l
- Location: Portugal
Correct float height
Hi to everyone on this forum.
I want to check the float height on my 55w using the drain tube up the side of the carb method. Ive found three different figures on the internet.
Can anyone tell me what the correct figure is.
Heres a pic of the level on mine.
Thanks.
I want to check the float height on my 55w using the drain tube up the side of the carb method. Ive found three different figures on the internet.
Can anyone tell me what the correct figure is.
Heres a pic of the level on mine.
Thanks.
-
charliext1vj
- Halfway there
- Posts: 321
- Joined: Sun Mar 29, 2015 11:12 am
- What Bike or Bikes Do You Own?: 2 XT600s -1VJ, BSA Bantam Trail, CRF1000, BSA B25 if I can find all the bits!
- Previously Owned Bikes: too many to list - XT600s, cr500, KTM 990 Adv, VFR800, RDs, DTs
- Location: Bath, UK
Re: Correct float height
I have always done the float height and i dont know if what I use if model specific - but you are welcome to them
circa 27mm to 29mm for float height and 6-8mm for Fuel Level
circa 27mm to 29mm for float height and 6-8mm for Fuel Level
-
simplesimon1
- No Gold Stars Yet
- Posts: 43
- Joined: Thu Sep 22, 2016 6:46 pm
- What Bike or Bikes Do You Own?: xt600z 1vj
- Previously Owned Bikes: xt600 34l
- Location: Portugal
Re: Correct float height
Ok.
Thanks for that.