Would metal shavings show up in the oil filter?

About air filters: go with oem. Aftermarket ones wont sit tight in its slot instead leaving a gap that gets you an airbox full of sand. Ask me how I know.

Choke rubber cover down by the carb is everything but tight, letting water and dirt get in there eventually making the choke stuck.

Now dying to know what a sprag is

I'm considering doing the conversion to my tt350, however it's far down om my to-do-list.

Don't know if the one from 2010 will fit but I'm selling one from 93. Send pm if you´re interested

Replaced the friction plates but didn't notice at first that the teeth on the metal clutch plates aren't uniformly placed around it but in groups of 5, 5, 5 and 4.

https://s8.postimg.cc/6efl7bp9d/WP_20180804_22_53_33_Pro_LI.jpg

Am i correct in thinking it doesn't matter as long as each plate ...

I don't know if this method is common wisdom but it should be on how to pull the flywheel on the 3yf engine and in this case simultaneously splitting the cases.

Parting out a spare engine time had come to remove the flywheel and open up the case. The standard way for most yamaha 600 and 660s is to ...

So I got the OEM ones off Kedo. Pricey but they fit

I recently rebuilt my forks for my 3TF and replaced the dust seals, but the replacements are different to the original ones.

The original seals fitted against the oil seal and under the retaining clip, however the replacements sent by wemoto fit outside and do not allow me to fit the retaining ...

Mine too, ended up looking like this https://s14.postimg.cc/eq44lfad9/WP_20171114_17_53_34_Pro.jpg with a gap cause you cant push the dust seal all the way since the circlip is there


Looking at ebay the dust seals come shaped differently from different manufacturers. I still don't know which are ...